Filter
Top Products
SKU 96728 For technical questions, please call 1-800-444-3353 Page 6
When a solar panel is connected to the Charge Regulator, the 2. YELLOW
(charging) LED light will illuminate to show that the 12 volt DC battery is receiving
charge from the solar panel. (See Figure A.)
The Charge Regulator provides the following protections for the entire system:3.
Over-Charge Protection: • When activated, the GREEN (over-charging) LED
light will illuminate. The Charge Regulator will automatically shut off power
input from the solar panel to the battery to prevent damage to the battery. In
this case, immediately disconnect the solar panel from the Charge Regulator.
(See Figure A.)
Discharge Protection: • When activated, the RED (discharge protection) LED
will illuminate. The Charge Regulator will automatically shut off power output to
prevent damage to the battery. In this case, discontinue using any application.
(See Figure A.)
INSPECTION, MAINTENANCE, CLEANING
BEFORE EACH USE: 1. Inspect the general condition of the Charge Regulator.
Check for broken parts, damaged wiring, and any other condition that may affect
its safe operation. Do not use damaged tools.
AFTER EACH USE: 2. Disconnect the Charge Regulator from the battery and
solar panels. Always disconnect the battery rst (negative terminal rst).
WHEN CLEANING: 3. Use a clean, damp cloth and mild detergent. Do not use
solvents. Do not immerse the Charge Regulator in liquid.
WHEN STORING: 4. Keep the Charge Regulator in a clean, dry, safe location out
of reach of children and other unauthorized people.
CAUTION! 5. All maintenance, service, and repairs not mentioned in this manual
must only be performed by a qualied service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.