Filter
Top Products
Page 6For technical questions, please call 1-800-444-3353.SKU 98107
mum speed marked on the power
tool. Accessories running faster than
their RATED SPEED can break and
The outside diameter and the 5.
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
guarded or controlled.
The arbor size of wheels, anges, 6.
backing pads or any other acces-
sory must properly t the spindle
of the power tool. Accessories with
arbor holes that do not match the
mounting hardware of the power tool
will run out of balance, vibrate exces-
sively and may cause loss of control.
Do not use a damaged accessory. 7.
Before each use inspect the ac-
cessory such as abrasive wheels
for chips and cracks, backing pad
for cracks, tear or excess wear,
wire brush for loose or cracked
wires. If power tool or accessory
is dropped, inspect for damage or
install an undamaged accessory.
After inspecting and installing an
accessory, position yourself and
bystanders away from the plane of
the rotating accessory and run the
power tool at maximum no-load
speed for one minute. Damaged
accessories will normally break apart
during this test time.
Wear personal protective equip-8.
ment. Depending on application,
use face shield, safety goggles
or safety glasses. As appropriate,
wear dust mask, hearing protec-
tors, gloves and workshop apron
capable of stopping small abra-
sive or work piece fragments. The
eye protection must be capable of
stopping ying debris generated
by various operations. The eye pro-
tection must be capable of stopping
operations. The dust mask or respira-
-
ticles generated by your operation.
Prolonged exposure to high intensity
noise may cause hearing loss.
Keep bystanders a safe distance 9.
away from work area. Anyone
entering the work area must wear
personal protective equipment.
Fragments of work piece or of a
cause injury beyond immediate area
of operation.
Hold power tool by insulated grip-10.
ping surfaces only, when perform-
ing an operation where the cutting
accessory may contact hidden
wiring or its own cord. Cutting ac-
make exposed metal parts of the
-
erator.
Position the cord clear of the spin-11.
ning accessory. If you lose control,
the cord may be cut or snagged and
your hand or arm may be pulled into
the spinning accessory.
Never lay the power tool down 12.
until the accessory has come to a
complete stop. The spinning acces-
sory may grab the surface and pull
the power tool out of your control.
Do not run the power tool while 13.
carrying it at your side. Accidental
contact with the spinning accessory