Filter
Top Products
SKU 98753 For technical questions, please call 1-800-444-3353. Page 8
welding rod into the tip of the Stitch
Welder. Secure the Rod Holder.
Clamp the electrode holder of the 6.
ARC welder onto the Connection (11)
of the Stitch Welder.
Adjust the output to no greater than 7.
50 Amps.
8. DANGER! To prevent serious
injury and death. If the operator
is not holding the Stitch Welder, it
must be sitting on a nonconduc-
tive, nonammable surface. The
Stitch Welder will immediately
turn on when the power button
is turned on. The connection be-
tween the Stitch Welder and the
electrode clamp of the ARC welder
must also be sitting on a noncon-
ductive, nonammable surface.
Turn on the ARC welder. 9.
When turned on the Stitch Welder will 10.
vibrate lightly; this is normal.
Using “tack welds” to secure two 11.
metal sheets together will help en-
welds are short welds intended to
secure the two workpieces together
Tack welds should begin in the center
of the sheeting and work outward al-
ternately until the edges are reached.
All tack welds should be properly
cleaned up before continuing to the
Apply the Stitch Welder to the sheet-12.
ing being welded; the arc will ignite.
Slowly draw the arc along the seam.
13.
trode from the workpiece, discharge
the electrode to ground and turn the
Welder off.
Place the Stitch Welder down on a 14.
-
face to cool.
Read the included Weld Diagnosis 15.
pamphlet for directions and welding
guidelines.
To prevent accidents, disconnect the 16.
Stitch Welder from the ARC welder
after use. Clean, then store the tool
indoors out of children’s reach.