Filter
Top Products
EN
ENGLISH
Clarke
®
American Sanders
Operator's Manual (EN) - Floorcrafter - 7 -
How to Transport the Machine
WARNING: The machine is heavy. Remove the
motor from the machine before
transporting. Get help loading the
machine and motor. Use proper
lifting techniques.
Transporting the Machine - Using the
Dolly Cart
CAUTION: When deploying the dolly, the drum
will contact the floor or ground over
which the machine is resting. Care
should be taken to avoid surfaces
which might damage or contaminate
the drum.
CAUTION: While transporting using the dolly,
abrupt changes in the direction of
travel or the surface over which the
machine is being transported could
cause the machine to tip over. Also,
the machine is more likely to tip
over when transporting across
inclined surfaces.
Attach the dolly to the rear of the machine as follows:
1. Open the quick release levers (2A) and unscrew the
adjustment nuts (2B) to allow installation of the dolly.
(See figure 2)
2. Insert the quick release skewers into the dolly brackets
and immediately tighten the adjustment nuts until the
dolly mechanism will just swing free.
Deploy the dolly under the machine as follows:
1. With the dolly mechanism in place as described above,
tip the machine by lifting up on the operators handle to
raise the rear of the machine off the floor/ground until
the dolly swings under the machine. (See figure 3)
2. Hold the dolly in position using your foot and allow the
machine to tip back and rest on the dolly wheels. (See
figure 4)
3. Tip the machine back on all four wheels and close the
quick release levers for transport. Some adjustment of
the quick release skewers may be necessary to allow
the levers to be tightened securely.
Removing/Storing the dolly:
The dolly can be stored on the machine in the "UP" posi-
tion or it can be removed and stored separately.
1. Open the quick release levers to loosen the dolly.
2. Lift up on the operators handle to tip the machine
forward.
3. Swing the dolly out from under the machine and lower
the machine until it rests on its own wheels.
CAUTION: Be careful when lowering the
machine. The dolly will swing back
toward the operator as the machine
is lowered.
Figure 4
Figure 3
Figure 2
AB B A