Filter
Top Products
Adjust the saw's floorlock/caster assembly to
the center height of the extrusion line using a 16- or 18-
inch adjustable wrench. Once the correct height is
reached, adjust the pad assembly to remove the weight
from the casters for operation. This minimizes machine
vibration during the cutting cycle.
Use a plumb line or laser to check for a
straight line
from the extrusion die through each line
component to the saw center line of the table. Adjust as
necessary.
POSITION THE
SAW
CONTINUED
UGE058/0803 CTS Saw
INSTALLATION 3-5
5
6