Filter
Top Products
INSTALLING BITS
F/gure 9.
• Lock the switchtrigger by piecing the direction ofrota-
tion selector in the center position.
• Open or close the chuckj_zwsto a pointwhere the
openingLsalight/largar then the bit elzeyou intend to
use. Also, raisethe front of the driftstighttyto keep the
b_ from fa_ling out of the chuckjaws.
• Insertthe drillbit straightintothe chuckthe full length
ofthe jaws.
• Tightenthe chuck jaws onthe drillbit.
_k WARNING: Make sure to insertthe drillbit straight
intothe chuckjaws. Do not insertthe drillbit into
the chuckjaws at an angle then tighten, as shownin
figure1O.Thlscould cause the drillbit to be thrown
from the drill,resultingin possib]e seriouspersonal
injuryor damageto the chuck.
DRILLBIT UNLOCK
. (RELEAEE)
CHUCK
COLLAR
LOCK
(TIGHTEN)
CHUCK
BODY
RIGHT Fig. 9
• TOtighten: grasp and hold the collarofthe chuck with
one hand,while ro'_ting the chuck bodywith your
otherhand.
NOTE: Rotate the chuck body inthe directionofthe
arrow marked LOCK to tighten the chuckjaws.
• Do not usea wrench to tighten or loosenthe chuck
ja.w8.
WRONG Fig.10
REMOVING BITS
See F_jure g.
• Lock the sw(tcht_gar by placingthe directionof rota-
tion selector in the center position.
• Loosenthe chuckjaws from the drillbiL
• To loosen:grasp and hold thecollar of the chuckwith
one hand,while ro_ting the chuck body with your
other hand.
NOTE: Rotatethe chuck body in the directionat the
arrow ma_sd UNLOCK to loosenthe chuckjaws.
• Do not use a wrench to tightenor loosenthe chuck
jaws.
• Remove the driftbit from the chuckjaws.
14