Filter
Top Products
Seeinstructionsonhowtoattachline
guardintheOperationsectionofthe
linetrimmermanual.Failuretoattach
thelineguardmayposea riskof
injury,maycausemotordamageand
willvoidthewarranty.
USEAHARDHAT-Alwaysweara
hardhatwhencuttingbranchesover-
headwiththepolesawtoreducethe
riskofinjuryfromfallingbranches.
READANDFOLLOWALLSAFETY
WARNINGprintedinthevarioustool
attachmentmanuals.
Toreduceriskwhenhandlingthe
battery:
DONOTdisposeofthebatteryina
fire.Thecellsmayexplode.Check
withlocalcodeforpossiblespecial
disposalinstructions.
DONOTopenormutilatethebattery.
Releasedelectrolyteiscorrosiveand
maycausedamagetotheeyesor
skin.Itmaybetoxicifswallowed.
EXERCISECAREinhandling
batteriesinordernottoshortthe
batterywithconductingmaterials
suchasrings,braceletsandkeys.The
batteryorconductormayoverheat
andcauseburns.
Toreduceriskwhenusingcharger:
DONOTusechargeroutdoorsorin
wetconditions;useinsideonly.
DONOTchargetheunitwhenthe
temperatureisbelow+40Forabove
+120F.Itmaylessentheservicelife
ofthebattery.
Thisunitanditschargeraredesigned
toworktogether.DONOTchargethe
batterywithanyotherchargerandDO
NOTusethischargerwithanyother
yardtoolorbattery.
Thechargerisdesignedtooperateon
120volts.DONOTattempttouseitat
anyothervoltage.
Storetheseinstructionsbyfoldingin
halfandslidingintotheslotintheback
ofthewaltchargingrack.
SAVE THESE INSTRUCTIONS
e" =_ ®
CHARGE BATTERY PRIOR TO
USE - The battery does not come
fully charged when purchased. Before
using the unit, the battery must be
charged. Before charging the battery,
read safety and charging instructions.
PROPER RUN TIME AND
PERFORMANCE can only be
obtained with a fully charged battery.
CHARGE TIME - Charging for
approximately 1 hour is sufficient to
replenish the battery to afull charge.
Initial use, long periods of inactivity, or
storage at extreme temperatures may
require extended charge time.
WALL CHARGE BRACKET - Before
charging the unit, make sure the
charge bracket is securely attached to
the walt; attach with screws to a wall
stud. The use of wall board anchors is
NOT recommended.
To Charge Battery:
1. Plug the charger into a 120 Volt AC
outlet.
2. Place the Power Handle with
battery attached into the wall charge
bracket. It is not necessary to remove
the tool attachment when charging the
battery. (see figure 1)
Figure 1