Important: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the tool better and safer.
SYMBOL
V
A
Hz
min
no
.../min
A
0
@
NAME
Volts
Amperes
Hertz
Minutes
Alternating Current
Direct Current
No Load Speed
Revolutions or Reciprocation Per Minute
Safety Alert Symbol
Wear Eye Protection
Wet Conditions Alert
DESIGNATION/EXPLANATION
Voltage
Current
Frequency (cycles per second)
Time
Type or a characteristic of current
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes,
surface speed, orbits etc. per minute
Indicates danger, warning orcaution.
It means attention!!! Your safety is
involved.
Always wear safety goggles or
safety glasses with side shields when
operating this product.
Do not expose to rain or use in damp
locations.
The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the
explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves
eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention
measures.
Symbol Meaning
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
,_ WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury. It may also be used to alert against unsafe practices that may cause property damage.
NOTE: Advises you of information or instructions vital to the operation or maintenance of the equipment.
SAVE THESE INSTRUCTIONS
6