Filter
Top Products
_iI_ WARNING:Donotwearlooseclothingor
jewelrywhenoperatingthistool.Theycouldget
caughtinmovingpartscausingseriousinjury.
Keepheadawayfromsander/polisherand
sandingorpolishingarea.Haircouldbedrawn
intosander/polishercausingseriousinjury.
INSTALLINGPOLISHINGBONNETS
SeeFigure6.
[] Unplugyoursander/polisher.
_ WARNING:Failureto unplugyoursander/
polishercouldresultinaccidentalstarting
causingpossibleseriouspersonalinjury.
[] Ifyouhavebeenusingthistoolasasander,re-
movespannernutandsandingdisc.
[] Slippolishingbonnetoverrubberdisc,pullstring
endstight,andtieina bowto securebonnet.
[] Tuckstringendsandbowunderneathbonnet.
_ WARNING:Failureto tuckstringendsandbow
underneathbonnetcouldresultinstringends
cominglooseandhittingorgrabbingforeign
objects.
POLISHING
SeeFigure7.
FORBESTRESULTS,ALWAYSOPERATEATLOW
SPEEDWHENPOLISHING.
Holdthetoolfirmly,allowingitto operatefreelywith-
outunnecessarypressure.Thistoolwasdesignedso
thattheweightofthetoolalonewillprovideadequate
pressureforpolishingattop efficiency.
BONNETSMUSTBEKEPTCLEANANDFREEFROM
GRIT,DIRT,ANDOTHERABRASIVEPARTICLES.
Whenbonnetsbecomedirtyandcloggedwithpol-
ishingfilm,washin lukewarmwaterwitha mildde-
tergent.Allowbonnetsto drythroughlybeforereuse.
Polishwitha longsweepingmotion,backandforth,
advancingalongthesurfaceto bepolished.Donot
holdthetoolinonespotor useacircularorspiralpat-
tern.Thiswillcauseswirlsinthefinish.Spreadalight
coatof polishorwaxoverasmallarea.Polishwith
thetoolaccordingto themanufacturer'sinstructions
printedonthelabelofthepolishorwaxcontainer.
Note:Somepolishesshouldbebuffedwhiledamp
whereothersmustbeallowedto dry;thereforealways
checkthemanufacturer'slabel.
Tiltthetoolsothatthepolishingbonnetisataslight
angletotheworksurface.Alwaysstartpolishingat
thetoporhighestpointandworkdown.Thiswillpre-
ventlightdustorpolishfilmfrombeingthrownupon
completedsection.Italsoeliminatespullingthetool's
BONNET
I
TUCKSTRING ENDS AND
BOWUNDERNEATH BONNET
Fig. 6
Fig. 7
power cord over sections already polished, particu-
larly on automobiles.
Surfaces that have an old film of wax or polish, or that
have not been polished or waxed for an extended pe-
riod of time, may require a second application. This is
especially true on oxidized surfaces. Heavily oxidized
surfaces should be cleaned with a commercial paste or
liquid cleaner before polishing or waxing.
_ ARNING: Check polishing bonnets before
each use. Make sure they are clean and free from
any loose particles or foreign objects that may be
embedded in the bonnet. Failure to do so could
cause these particles or objects to be thrown
from the tool resulting in possible serious injury.
10