Filter
Top Products
A
A
WARNING: When servicing, use only identical
Craftsman replacement parts. Use of any other part
may create a hazard or cause product damage.
WARNING: Always wear safety goggles or safety
glasses with side shields when using compressed air
to clean products. If the operation is dusty, also wear
a dust mask.
A
WARNING: To avoid serious personal injury, always
remove the battery pack from the product when
cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
A
WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic which
may result in serious personal injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts
should be replaced at a Sears Service Center.
REPLACING BULBS
See Figures 5 - 7.
Over time, the bulb will burn out. When this occurs,
replacing the bulb will be necessary. Be careful not to
touch the bulb glass. This will reduce the life of the bulb.
To replace a bulb:
• Remove battery from the spotlight and let it cool for at
least 5 minutes.
• Turn the bezel counterclockwise to remove.
LENS LENS
SEAL
TO
REMOVE
_.,,_ REPLACE
_ GROOVE
BEZEL
REFLECTOR
RIDGE
NOTCHES
REFLECTOR
ASSEMBLY Fig. 5
• Remove the reflector assembly from the spotlight
housing. Do not pull on the leads connected to the
assembly.
• Remove the white connection point from its nest in the
housing.
RETAINER
PIN
CONNECTION
POINT
REFLECTOR
ASSEMBLY
WHITE
RED CONNECTION
CIRCUIT TERMINAL
LEAD
CONNECTION
POINTNEST
Fig. 6
• Remove the white connection terminal from its
connection point.
NOTE: Do not pull white lead without holding the
connection point, as this may damage lead.
• Remove the retainer pin from the reflector and remove
bulb assembly. Bulb assembly may be rotated in
reflector if needed to aid in removal.
• Install new bulb assembly.
• Replace bulb retainer pin.
• Hold white connection terminal and reconnect white
lead.
• Return the white connection point to its nest.
• Align tabs on each side of lens seal with notches on
spotlight housing and seat lens seal in place.
• Reattach bezel carefully by rotating clockwise.
• Tighten securely.
NOTE: Always ask for replacement bulb H3 6V55W,
number 019020001007.
CAUTION: Do not use a higher rated bulb other
than the specified wattage. This could cause
damage to the product.