Filter
Top Products
KEYLESS CHUCK
See Figure 11.
A keyless chuck has been provided with your drill to allow
for easy installation and removal of bits. As the name
implies, you can hand tighten or release drill bits in the
chuck jaws. Arrows on the chuck indicate which direction
to rotate the chuck sleeve in order to LOCK (tighten) or
UNLOCK (release) the chuck jaws. Loosen the chuck
sleeve by rotating it counterclockwise with one hand.
Insert drill bit into the chuck the full length of the jaws,
tighten securely by rotating the chuck sleeve in clockwise
direction.
DRU.BIT
Fig. 11
,_ WARNING: Do not hold chuck sleeve with one
hand and use power of the drill to tighten chuck jaws
on drill bit. Chuck sleeve could slip in your hand or
your hand could slip and come in contact with
rotating drill bit. This could cause an accident
resulting in serious personal injury.
Fig. 12
Note: Remember the two-speed feature (HI-I.O) when
setting torque. The amount of torque will vary depending
on which speed setting you have your drill-driver. Switch-
ing to LO speed will increase torque. Switching to HI
speed will decrease torque.
BIT STORAGE
See Figure 13.
When not in use, bits provided with your drill can be
placed in the storage area located on the top of your drill
as shown in Figure 13.
BTSTORAGEN]EA
ADJUSTABLE TORQUE CLUTCH
Your drill is equipped with an adjustable torque clutch for
driving different types of screws into different materials.
The proper setting depends on the type of material and
the size of screw you are using.
TO ADJUST TORQUE
• identify the twenty four torque indicator settings
located on the front of your drill. See Figure 12.
• Rotate adjusting ring to the desired setting.
1 - 4 For driving small screws.
• 5 - 8 For driving screws into soft
material.
• 9 - 12 For driving screws into soft and
hard materials.
• 13 - 16 For driving screws in hard wood.
• 17 - 20 For driving large screws.
• 21 -_11 For heavy drilling.
12
Fig 13