Filter
Top Products
6
KNOW YOUR RECIPROCATING SAW
See Figure 1.
Before attempting to use your reciprocating saw,
familiarize yourself with all operating features and safety
requirements.
WARNING: Carefully read through this entire owner's
manual before using your new reciprocating saw. Pay
close attention to the Rules For Safe Operation,
Warnings and Cautions. If you use your reciprocating
saw properly and only for what it is intended, you will
enjoy years of safe, reliable service.
Your reciprocating saw has been shipped completely
assembled except for the blade. Inspect it carefully to
make sure no breakage or damage has occurred during
shipping. If any parts are damaged or missing, contact
your nearest Sears Retail Store to obtain replacement
parts before attempting to operate saw. Two blades, blade
wrench (5 mm hex key) and this owner's manual are also
included.
WARNING: Do not allow familiarity with your saw to
make you careless. Remember that a careless fraction
of a second is sufficient to inflict severe injury.
BLADE WRENCH HOLDER
A blade wrench (5 mm hex key) is packed with your saw.
A convenient feature on your saw is the wrench holder.
This is a slot located on the bottom portion of the saw
handle. It is convenient for storing the wrench when it is
not being used.
LOCK-OFF BUTTON
Your saw is equipped with a "lock-off" button which
reduces the possibility of accidental starting. The lock-off
button is located on the handle above the switch trigger.
You must depress the lock-off button in order to pull the
switch trigger. The lock resets each time the trigger is
released. Note: You can depress the lock-off button from
either the left or right side.
SWITCH
To turn your saw ON, depress the lock-off button and pull
switch trigger. Release switch trigger to turn your saw
OFF.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
APPLICATIONS
(Use only for the purposes listed below)
■ Cutting all types of wood products (lumber, plywood,
paneling, composition board, and hard wood).
■ Cutting masonite and plastic.
■ Cutting drywall.
■ Cutting metals such as sheet steel, pipe, steel rods,
aluminum, brass, and copper.
WARNING: If any parts are missing, do not operate
your saw until the missing parts are replaced. Failure to
do so could result in possible serious personal injury.
PRODUCT SPECIFICATIONS
RECIPROCATING SAW 315.271290
Blade Stroke 1-3/16 in.
Motor 18 Volt DC
No Load Speed 0-2500 SPM
Switch Variable Speed
Shank Capacity 1/2 in.
CHARGER ITEM NO. 9-11040
(981399-001)
Input 120 Volts, 60 Hz, AC only
Charger Voltage 9.6 - 24 Volt
Charger Rate 1 Hour
BATTERY PACK ITEM NO. 9-11034
(981404-001)
FEATURES