Filter
Top Products
CHUCK REMOVAL (Continued)
• Insert hex key wrench in chuck and tighten chuck
jaws securely. Tap sharply with a mallet in a
counterclockwise direction. This will loosen chuck
on the spindle. It can now be unscrewed by hand.
See Figure 14.
Fig. 14
TO RETIGHTEN A LOOSE CHUCK
The chuck may become loose on spindle and develop
a wobble. Also, the chuck screw may become loose
causing the chuck jaws to bind and prevent them from
closing. To tighten, follow these steps:
• Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
• Insert hex key wrench into chuck and tighten
chuck jaws securely. Tap hex key wrench sharply
with a mallet in a clockwise direction. This will
tighten chuck on the spindle.
• Open the chuck jaws and remove hex key
wrench.
• Tighten the chuck screw. Note: The chuck screw
has left hand threads.
,_ WARNING: When servicing, use only identical
Craftsman replacement parts. Use of any other
part may create a hazard or cause product
damage.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
_k WARNING: Do not at any time let brake fluids
gasoline, petroleum-based products, penetratinc
oils, etc. come in contact with plastic parts. The'
contain chemicals that can damage, weaken or
destroy plastic.
Do not abuse power tools. Abusive practices can
damage tool as well as workpiece.
Only the parts shown on parts list, page 15, are
intended to be repaired or replaced by the customer.
All other parts should be replaced by a qualified
service technician at an authorized service facility.
d_ll WARNING: Do not attempt to modify this tool or
create accessories not recommended for use
with this tool. Any such alteration or modification
is misuse and could result in a hazardous
condition leading to possible serious personal
injury.
BATTERIES
Your drill's battery pack is equipped with 12 nickel-
cadmium rechargeable batteries. Length of service
from each charging will depend on the type of work
you are doing.
The batteries in this tool have been designed to
provide maximum trouble free life. However, like all
batteries, they will eventually wear out. Do not
disassemble battery pack and attempt to replace the
batteries. Handling of these batteries, especially when
wearing rings and jewelry, could result in a serious
burn.
To obtain the longest possible battery life, we suggest
the following:
• Store and charge your batteries in a cool area.
Temperatures above normal room temperature
will shorten battery life.
• Never store batteries in a discharged condition.
Recharge them immediately after they are
discharged.
• All batteries gradually lose their charge. The
higher the temperature the quicker they lose their
charge. If you store your tool for long periods of
time without using it, recharge the batteries every
month or two. This practice will prolong battery
life.
12