Filter
Top Products
,_ WARNING: When servicing, use only identical
Craftsman replacement parts. Use of any other
part may create a hazard or cause product
damage.
Avoid using solvents when cleaning plastic pads.
Most plastics ere susceptible to damage from various
types of commemial solvents and may be damaged
bytheir use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
_ WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic pads. They
contain chemicals that can damage, weaken or
destroy plastic.
Do not abuse power tools. Abusive practices can
damage tool as well as workpiece.
Only the parts shown on parts list, page fifteen, are
intended to be repaired or replaced by the customer.
All other parts should be replaced by a qualified
service technician at an authodzed service facility.
_i, WARNING: Do not attempt to modify this tool or
create accessodes not recommended for use
with this tool. Any such alteration or modification
is misuse and could result in a hazardous
condition leading to possible serious personal
injury.
BATTERIES
Your drill's battery pack is equipped with 10 nickel-
cadmium rechargeable batteries. Length of service
from each charging will depend on the type of work
you are doing.
The battedes in this tool have been designed to
provide maximum trouble free life. However, like all
batteries, they will eventually wear out. Do not
disassemble battery pack and attempt to replace the
battedes. Handling of these batteries, especially
when wearing rings and jewelry, could result in a
serious burn.
To obtain the longest possible battery life, we suggest
the following:
• Store and charge your batteries in a cool area.
Temperatures above normal room temperature
will shorten battery life.
• Never store battedas in a discharged condition.
Recharge them immediately after they are
discharged.
• All batteries gradually lose their charge. The
higher the temperature the quicker they lose their
charge. If you store your tool for long periods of
time without using it, recharge the batteries every
month or two. This practice will prolong battery
life.
OVERLOAD
Your ddll has a built-in overload protector to protect
the motor during overloading or prolonged use. The
overload protector automatically activates to break the
circuit. When this occurs, allow your drillto cool a few
seconds before resuming operation.
13