Filter
Top Products
6. Insert each new LED assembly through the hole where the original bulb and connector were
located. Use caution when feeding the wires through the socket opening to avoid damaging
the wire insulation.
7. Feed the wires through the large hole in the back plate and attach the
back plate onto the back side of the housing. The flat side of the
mounting plate should be toward the outside and the side with the
slight raised center should go in toward the housing. This will align t
mount in the original housing.
he
8. Secure the LED assembly into the housing with the supplied back plate and #6 lock nuts.
9. Place the original lens gasket into place and replace the tail light lens.
MAN#650236