Filter
Top Products
7
ASSEMBLY
1. Assemble the column (A) Fig. 3, to the base (B) using
the four M8x25mm hex head screws (C), three of which
are shown. Loosen set screw (D) and remove ring (E) and
raising rack (F).
2. Make certain worm gear (G) Figs. 4 and 5, is in place
in table bracket (H) as shown.
3. Insert raising rack (F) Fig. 6, which was removed in
STEP 1, into groove in table bracket making sure teeth
of worm gear (G) located inside table bracket are
engaged with teeth of raising rack (F).
Fig. 3
Fig. 4
Fig. 6
H
G
F
G
A
B
C
C
F
E
D
Fig. 5
G
H