Filter
Top Products
66
FOREWORD
FUNCTIONAL DESCRIPTION
NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE CURRENT PRODUCTION
MODEL. ALL OTHER ILLUSTRATIONS CONTAINED IN THE MANUAL ARE REPRESENTATIVE ONLY
AND MAY NOT DEPICT THE ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED
TO ILLUSTRATE TECHNIQUE ONLY.
The Delta Indusrial Model 22-450 (DC-580) 20" Planer has a 3-phase, 5HP motor with an LVC magnetic starter and
automatic reset overload protection; 3-knife cutterhead, sectional serrated infeed roll, double bed rollers and
polyurethane outfeed roller, sectional chipbreakers, dust chute, knife-setting gage, and wrench. The Delta Industrial
Model 22-451 (DC-580) 20" Planer is the same as above except with a single-phase, 5HP motor.
THIS MACHINE MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM
ELECTRIC SHOCK.
GROUNDING INSTRUCTIONS
These machines are not supplied with power cords and they are intended to be permanently connected to the building’s
elecrical system. All wiring must be done by a qualified electrician and conform to the National Electric Code and all local codes
and ordinances. For wiring instructions, see section “ELECTRICAL CONNECTIONS” in this manual.
LVC MAGNETIC MOTOR CONTROL: If you purchased a machine that has a Low Voltage Magnetic Motor Control System,
refer to its instruction manual for installation guidance.
MOTOR SPECIFICATIONS
Your machine has a 5HP motor that is wired at 220 volts and 60 HZ alternating current. It may be wired for three
phase or single phase operation - check the spec plate on the motor.
A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should be
protected with a 20 Amp time lag fuse. Before connecting the machine to the power line, make sure the switch (s) is in the
“OFF” position and be sure that the electric current is of the same characteristics as indicated on the machine. All line
connections should make good contact. Running on low voltage will damage the machine.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP LOCATIONS.
POWER CONNECTIONS