Filter
Top Products
27
Fig. 74
Fig. 75
Fig. 72 Fig. 73
Fig. 71
1. Dadoing is cutting a rabbet or wide groove into the
work. Most dado head sets are made up of two outside
saws and four or five inside cutters, (Fig. 71). Various
combinations of saws and cutters are used to cut
grooves from 1/8" to 13/16" for use in shelving, making
joints, tenoning, grooving, etc. The cutters are heavily
swaged and must be arranged so that this heavy portion
falls in the gullets of the outside saws, as shown in Fig.
72. The saw and cutter overlap is shown in Fig. 73, (A)
being the outside saw, (B) an inside cutter, and (C) a
paper washer or washers, used as needed to control the
exact width of groove. A 1/4" groove is cut by using the
two outside saws. The teeth of the saws should be
positioned so that the raker on one saw is beside the
cutting teeth on the other saw.
2. Attach the dado head set (D) Fig. 74, to the saw arbor.
NOTE: THE OUTSIDE ARBOR FLANGE CAN NOT BE
USED WITH THE DADO HEAD SET, TIGHTEN
THE
ARBOR NUT AGAINST THE DADO HEAD SET BODY.
DO NOT LOSE THE OUTSIDE ARBOR FLANGE. IT
WILL BE NEEDED WHEN REATTACHING A BLADE TO
THE ARBOR.
THE ACCESSORY DADO HEAD SET
TABLE INSERT (E) FIG. 74, MUST BE USED IN PLACE
OF THE STANDARD TABLE INSERT.
3. Fig. 75, shows a typical dado operation using the miter
gage as a guide.
NEVER USE THE DADO HEAD IN A
BEVEL POSITION.
ALWAYS INSTALL BLADE GUARD
AFTER OPERATION IS COMPLETED.
USING DADO HEAD
THE BLADE GUARD AND SPLITTER
ASSEMBLY CANNOT BE USED WHEN DADOING OR
MOULDING. IT CAN BE SWUNG TO THE REAR OF
THE SAW AS DESCRIBED IN “USING ACCESSORY
MOULDING CUTTERHEAD” SECTION.
AUXILIARY JIGS, FIXTURES, PUSH
STICKS AND FEATHER BOARDS SHOULD BE USED.
A
B
C
ACCESSORY DADO HEAD
Fig. 70
C
D
E
SPECIAL ATTENTION SHOULD BE
GIVEN THE GRAIN DIRECTION. MAKE ALL CUTS IN
THE SAME DIRECTION AS THE GRAIN WHENEVER
POSSIBLE.
ALWAYS INSTALL BLADE GUARD
AFTER OPERATION IS COMPLETE.