Filter
Top Products
Use a light oil to lubricate eccentric (A) Fig. 79, and pivot points (B) on both the headstock and the tailstock. (Tailstock
illustrated).
Use the tip of a screwdriver (A) Fig. 80 to press on the opening, and drop light oil into the handwheel cover (B) of the
tailstock.
B
A
B
A
LUBRICATION
A
B
A
7. While holding the control panel (A) Fig. 77 with one hand, remove the cover (B) Fig. 77. To prevent the control panel
(A) from falling, loosely re-attach the Allen screw (B) Fig. 76 to the control panel.
8. Replace belt.
9. To assemble, reverse the procedure.
22
Fig. 75
A
A
B
5. Use a Phillips screwdriver (A) Fig. 75 to remove the five cover screws (B) (three of which are shown). The other two
screws are located under the power cords.
6. With a 5/16” Allen wrench (A) Fig 75, remove Allen screw (B) Fig. 76. NOTE: When re-assembling, make sure that
the screw passes completely through the pivoting control bracket and into the headstock, allowing the headstock
cover to pivot.
B
Fig. 76
Fig. 77
Fig. 78
Fig. 79
Fig. 77