Filter
Top Products
12
ATTACHING HOSE TO INTAKE PORT
DISCONNECT MACHINE FROM
POWER SOURCE BEFORE CONNECTING OR
DISCONNECTING HOSE .
Model 50-760 provides two 4” dust ports. Proceed as
follows for each port with your hose.
NOTE: Place open end (D) of intake cap rings around
and onto ends of each dust intake port before attaching
the hose.
To assemble the 4” dust collection hose to the motor
and blower assembly, loosely attach hose clamp (A) Fig.
13, around one end of flexible hose (B) and assemble the
hose to dust intake port (C). Tighten hose clamp (A).
Assemble the remaining clamp to the other end of the
flexible hose and to the woodworking machine.
NOTE: Do not operate the dust collector with either of
the holes in dust intake port (C) Fig. 13 uncovered. To
cover a hole not being used by a hose, place the flat
intake cap (E) on dust intake port as shown in Fig. 13.
Fig. 13
A
B
C
E
Fig. 11
Fig. 12
ATTACHING TOP FILTER BAG
1. Assemble large 5/16” flatwasher onto 5/16” hex
head screw.
2. Position bracket (A) to dust collector as shown in
Fig. 11.
3. Insert 5/16” hex head screw through hole in bracket
and thread into the hole in dust collector. Tighten
securely with a 12 mm wrench.
4. Insert rod (A) Fig. 12 into pocket on filter bag.
5. Insert rod (A) into hole in bracket (B).
6. Work open end of filter bag into top groove of dust
collector drum until secure and sealed. It will be
necessary to bend and fold the internal bag retainer
ring to fit it into place.
A
B
A
D
DISCONNECT MACHINE FROM POWER
SOURCE