Filter
Top Products
8
ASSEMBLING DUST INTAKE
HOSE TO MOTOR AND
BLOWER ASSEMBLY
The dust collector is supplied with a 4" flexible dust
intake hose. Place the intake cap holder (E) on the dust
collector as shown in Fig. 17. NOTE: DO NOT COVER
THE INTAKE PORT WITH THE INTAKE CAP WHEN
ATTACHING THE HOSE TO THE INTAKE PORT.
To assemble the dust collection hose to the motor and
blower assembly, loosely attach hose clamp (A) Fig. 17,
around one end of flexible hose (B) and assemble the
hose to dust intake port (C). Tighten hose clamp (A)
Fig. 18. Assemble the remaining clamp to the other end
of the flexible hose and to the woodworking machine.
IMPORTANT: Do not operate the dust collector without
the flexible hose assembled to the dust intake port.
Always disconnect dust collector from the power source
before connecting or disconnecting an air intake hose to
or from the blower and motor assembly.
CONNECTING TOOL TO POWER SOURCE
POWER CONNECTIONS
A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should be
protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have 3-
prong grounding type plugs and 3-hole receptacles which accept the tool’s plug. Before connecting the motor to the
power line, make sure the switch is in the “OFF” position and be sure that the electric current is of the same
characteristics as indicated on the tool. All line connections should make good contact. Running on low voltage will
damage the motor.
MOTOR SPECIFICATIONS
Your tool is wired for 120 volt, 60 HZ alternating current. Before connecting the tool to the power source, make sure
the switch is in the “OFF” position.
GROUNDING INSTRUCTIONS
WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM
ELECTRIC SHOCK.
This tool must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This tool is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be inserted into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING: Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly
grounded. Do not modify the plug provided with the dust collector. If it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
Fig. 17
Fig. 18
E
A
C
A
B
D