Filter
Top Products
8
Fig. 18
Fig. 19
Fig. 21
Fig. 20
11. Align two mounting holes in the top of drum support
arm (T) Fig. 18, with two pre-drilled holes in drum (N)
and fasten drum support arm (T) to drum (N). Place a
lockwasher then a flat washer onto the hex head screw,
insert the hex head screw through the hole in upper
drum support and drum and thread a hex nut onto the
hex head screw. NOTE: Do not completely tighten
mounting hardware at this time.
12. Fasten the bottom of drum support (T) Fig. 19, at
one corner of base (B). Place a lockwasher (X) onto a
hex head screw (W) and insert the hex head screw
through drum support arm (T) and thread into base (B).
Fasten the remaining drum supports Fig. 20, to the other
drum and base in the same manner.
13. Tighten all mounting hardware at this time.
14. Attach the lower dust bag retaining clip (A) Fig. 20, to
the dust collector drum. Align the two holes in the
retaining clip (A) Fig. 20, with the two holes in the drum.
Insert a 1/4-20x5/8" hex head screw through the holes in
the retaining clip and the holes in the drum. Place a 1/4"
flat washer onto the screws, and thread 1/4-20 hex nut
on the screws and tighten securely. Repeat this process
for the three remaining sides of the drum and the other
drum.
14. Fig. 21, illustrates four drum supports assembled to
the drums and base.
N
T
T
B
X
W
A