Filter
Top Products
9
9
INSTALLING THE DUST PORT TUBE AND THE DUST COLLECTOR CONNECTOR
Disconnect the machine from the power source!
1. Place the tube clamp (A) Fig. 7 on the lower support tube holder (B).
2. Insert the lower tube support (A) into the tube support holder (B) (Fig. 8).
3. Place a tube clamp (A) on the lower tube support (Fig. 9).
Fig. 7
Fig. 8
Fig. 9
4. Align the two holes in the intake support angle brace (A) Fig. 10 with the two holes in the intake funnel (B).
5. Fasten the intake support angle brace to the intake funnel by inserting the two 5/16-18x5/8" button-head carriage
bolts (C) through the intake funnel (B) and the intake support angle brace (A) (Fig. 11).
Fig. 10
Fig. 11
A
B
A
A
B
A
B
A
B
C
6. Thread a 5/16-18" flange hex nut (C) Fig. 12 on the bolt (B). Tighten securely.
7. Attach the upper support bracket (B) Fig. 13 to the intake support angle brace (C) with the adjustable locking lever
(D).
NOTE: Place an M8.4 flat washer and a 5/16” lockwasher on the locking lever screw before attaching it to the intake
support angle brace.
Fig. 12
B
C
Fig. 13
D
C
B