ADDITIONAL SPECIFIC SAFETY RULES
FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS INJURY.
SAVE THESE INSTRUCTIONS.
Refer to them often
and use them to instruct others
.
DO NOT USE THIS UNIT TO FILTER
METAL DUST. Combining wood and
metal dust can create an explosion or
fire hazard. This unit is intended to filter
non-explosive atmospheres only.
DO NOT USE THIS UNIT TO DISSIPATE
FUMES OR SMOKE. Explosions or fire can
result. This dust collector is intended for
use where only dry airborne dust is
present. Its use should be limited to non-
explosive, non-metallic atmospheres.
1. DO NOT OPERATE THIS UNIT UNTIL IT IS
COMPLETELY ASSEMBLED AND INSTALLED
ACCORDING TO THE INSTRUCTIONS. A unit
incorrectly assembled can cause injury.
2. OBTAIN ADVICE FROM YOUR SUPERVISOR,
INSTRUCTOR, OR ANOTHER QUALIFIED
PERSON if you are not thoroughly familiar with the
operation of this unit. Knowledge is safety
3. FOLLOW ALL WIRING CODES and recommended
electrical connections to prevent electrical shock
or electrocution.
4. DO NOT PULL THIS UNIT BY THE POWER
CORD. Do not allow the power cord to come in
contact with sharp instruments or edges, hot
surfaces, or oil or grease. Do not place any weight
on top of the power cord. A damaged power cord
can cause electrical shock or electrocution.
5. SUPPORT THIS UNIT OR SECURELY CLAMP IT
TO THE WORK SURFACE WHEN IT IS USED IN
A PORTABLE APPLICATION to eliminate potential
injury and/or damage from falling.
6. ENSURE THAT THE INTAKE AND EXHAUST
AREAS ARE CLEAR PRIOR TO STARTING THE
UNIT.
Clogged intakes or exhausts can cause an
explosion and/or fire.
7. DO NOT USE THE DUST COLLECTOR to pick up
flammable liquids such as gasoline. Do not use the
dust collector near flammable or combustible
liquids. Explosion and/or fire can occur.
8. KEEP ARMS, HANDS, AND FINGERS AWAY
FROM THE FAN. Avoid all exposure to rotating
parts to prevent injury.
9. DO NOT OPERATE THIS UNIT WITHOUT THE DUST
COLLECTION BAG IN PLACE AND PROPERLY
SECURED. Sawdust and other debris can provide the
potential for fire and/or explosion and can also cause
inhalation problems.
10. INSPECT THE DUST BAG FOR CUTS, RIPS, OR
TEARS. Replace damaged bags or vacuum hoses.
Sawdust and other debris can provide the potential for fire
and/or explosion and can also cause inhalation problems.
11. ALWAYS USE THE INTAKE CAPS TO COVER
UNUSED DUST PORTS. Debris can cause
damage to the unit and injury.
12. DO NOT ATTEMPT TO REMOVE OR REPLACE
the dust collection bag(s) while the unit is
connected to the power source.
Exposed fan blades
can cause severe injuries.
13. MAINTAIN THE UNIT IN TOP CONDITION.
Clogged filters can increase the potential for fire or
explosion. Follow all instructions for changing and
cleaning filters.
14. STORE THIS UNIT IN A LOCATION that
eliminates the potential for damage to the power
cord. A damaged power cord can cause shock or
electrocution. Safely store power cord on the unit
to eliminate tripping hazards.
15. TURN THE UNIT “OFF” AND DISCONNECT
THE UNIT from the power source before
installing or removing accessories, before
adjusting or changing set-ups, or when making
repairs. An accidental start-up can cause serious
injury.
16. TURN THE UNIT “OFF”, disconnect the unit
from the power source, and clean the table/work
area before leaving the area.
5