Filter
Top Products
8
Fig. 19
Fig. 18
Fig. 21
Fig. 23
A
Fig. 22
A
Fig. 20
PREPARING THE TOOL
1. After reading and understanding this entire manual, connect tool to
air supply (Fig. 18).
2. Depress latch and slide magazine cover open (Fig. 19).
3. Insert a strip of approved fasteners (Fig. 20 and/or Fig. 20A). Orient
fasteners with points down in the magazine. NOTE: Brad nails are side
loaded and staples are top loaded.
4. Push magazine cover closed (Fig. 21).
5. Observe the low fastener indicator (A) Fig. 22 and reload as needed.
6. Adjust directional exhaust deflector (A) Fig. 23, so that the exhaust air
or debris will be directed away from the operator. Grasp the deflector
and rotate it to the desired position for the current application.
Fig. 20A