Delta SM300 Drill User Manual


 
10
Fig. 15
Fig. 16
R
Q
S
T
10. IMPORTANT: Make certain the spindle taper (Q) Fig.
15, and tapered hole in chuck (R) are clean and free of
any grease, lacquer or rust preventive coatings.
NOTE: Household oven cleaner can effectively remove
any sub-stance from the spindle and chuck; however,
carefully follow the manufacturer's safety rules
concerning its use.
11. IMPORTANT: Open the chuck jaws as wide as
possible by turning the chuck sleeve (S) Fig. 16.
12. Holding chuck on taper of spindle, tap with a soft tip
hammer (T) or a block of wood and hammer to set chuck,
as shown in Fig. 16. IMPORTANT: To avoid damage to
the chuck, NEVER drive the chuck onto the spindle with
a metal hammer.
FASTENING DRILL PRESS
TO SUPPORTING SURFACE
If during operation there is any tendency for the machine
to tip over, slide or walk on the supporting surface, the
machine base must be secured to the supporting surface
with a M8x1.25x125mm carriage head screw, 8.5mm flat
washer, 8.5mm lock washer, M8x1.25 hex nut, through
the two holes (A) Fig. 17, located in the machine base.
Fig. 17
A
OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING
DRILL PRESS
The switch (A) Fig. 18, is located on the front of the drill
press head. To turn the drill press “ON” move the switch
up to the “ON” position. To turn the drill press “OFF”
move the switch down to the “OFF” position.
Fig. 18
A