Filter
Top Products
9
Fig. 4
Fig. 5
Fig. 6
A
A
A
B
C
A
LOWERING
EXTENSION TABLES
The infeed and outfeed table extensions (A) Fig. 4, are
shipped attached to the machine in the “UP” position.
Rotate both table extensions to the down position as
shown. The top surface of the table extensions should
be level with the planer table. To check and adjust if
necessary, refer to the section of this manual entitled
“LEVELING TABLE EXTENSIONS.”
CUTTERHEAD
LOCK HANDLE
1. Assemble the cutterhead lock handle (A) Fig. 5, to
shaft (B).
2. Fasten cutterhead lock handle (A) Fig. 6, to the shaft
using the M6x20mm special hex socket head screw (C),
with wrench supplied.
CUTTERHEAD RAISING AND
LOWERING HANDLE
1. Assemble the cutterhead raising and lowering handle
(A) Fig. 7, to shaft (B), making certain flat on shaft is
engaged with flat in handle.
Fig. 7
A
B