Filter
Top Products
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifi cations
Multi-zone Operations
Turning the Power On and Off
GOperation on the main unitH
Press <ZONE2 ON/OFF>.
When the power turns on, the multi-zone indicator ( ) lights on
the display.
GOperation on the remote control unitH
In the zone mode you want to operate, press [ZONE2 ON] or [ZONE2
OFF].
Turning off the Sound Temporarily
q Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2]
to “ZONE2”.
w Press [MUTING].
The sound is reduced to the level set at menu “Manual Setup”
– “ZONE2 Setup” – “Mute Level” (vpage 32).
To cancel, either adjust the volume or press [MUTING] again.
The setting is canceled when the zone’s power is turned off.
• The source selected for ZONE2 is also output from the recording
output connectors.
• When the input source to which the digital input connectors
(OPTICAL/COAXIAL) are assigned is selected in ZONE2, playback is
only possible if the digital signal being input is in PCM (2-channel)
format.
NOTE
• Digital audio signals input from the HDMI connectors cannot be
played in multi-zone.
• When certain digital signals are being input, noise may be output
from the ZONE2 audio output connectors.
Adjusting the Volume
GOperation on the main unitH
q Press <ZONE2 / REC SELECT> and select the zone to be adjusted.
w Turn <VOLUME> to adjust.
GOperation on the remote control unitH
q Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2]
to “ZONE2”.
w Press [VOLUME].
– – –
–70dB
~
–40dB
~
+18dB[Variable range]
Selecting the Input Source
GOperation on the main unitH
q Press <ZONE2 / REC SELECT> and select the zone to be adjusted.
w Turn <SOURCE SELECT>.
GOperation on the remote control unitH
q Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2]
to “ZONE2”.
w Press [SOURCE SELECT].
• Also press [SOURCE SELECT] when in standby mode, the power
turns on.
• When using ZONE2, it is possible to turn the power for the MAIN
ZONE only on or off by pressing [MAIN ON] or [MAIN OFF].
Multi-zone
<ZONE2 ON/OFF>
<VOLUME><SOURCE SELECT>
<ZONE2 / REC SELECT>
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
• The volume can be increased up to the value set at menu “Manual
Setup” – “ZONE2 Setup” – “Volume Limit” (vpage 32).
• The ZONE2 volume can be adjusted only when “ZONE2” is selected
at menu “Manual Setup” – “Option Setup” – “Amp Assign”
(vpage 32).
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[SOURCE
SELECT]
[VOLUME]
[MUTING]
[ZONE2 ON]
[MAIN ON]
[MAIN OFF]
[SOURCE
SELECT]
[ZONE2 OFF]
[Front] [Rear]