Filter
Top Products
3
108056 www.desatech.com
Figure 3
Figure 6Figure 5
Figure 4
Loading Tool
1. Lock handle (see
Locking Handle,
page
2).
2. Turn StrapGun™ upside down. At rear of
tool, squeeze latch on end of magazine
(see Figure 4). Pull rail out of magazine
until it stops (see Figure 4).
3. Drop straps into magazine. Make sure in-
sulator is facing up (see Figure 4).
4. Slide rail back into magazine until it locks
into place.
Operating Tool
1. Unlock handle if locked.
2. Grip tool firmly. Position the wire guide
on the front of the tool over the cable.
Note:
Hold tool flat against work sur-
face (see Figure 5).
3. Depress handle firmly to fire. Do not allow
tool to jump or recoil.
Note:
A better fas-
tening is possible if the thumb or palm of
free hand presses firmly against head of
tool (see Figure 6).
Application Notes
1. Due to the limitations of a manual tool,
this product can not drive straps com-
pletely into all areas of wood. Avoid knots
and dense, high resin areas.
2. If a fastening failure occurs, clear the strap
and any material in the front of the maga-
zine completely out. This will significantly
reduce the chance of reoccurrence.
Handle
Handle
Lock
Straps with Points
Facing Up
Insulator Magazine
Rail
Cable
Wire Guide