Filter
Top Products
3
18. Hot melt glue is not resistant to flammable liquids. Do not use to repair fuel tanks.
19. Do not attempt to repair tool or replace broken parts. Any servicing should be done
by factory service center.
Keep these operating instructions for reference. It is your guide to safe and proper
operation of this tool.
1. Attach wire stand to tool. Snap open ends of stand into holes near nose of tool. Use
stand when setting hot tool down. This allows good ventilation for the tool. Do not lay
hot tool on its side.
2. Plug power cord into a standard outlet. Use extension cord if needed.
3. Insert glue stick into rear opening of tool.
4. Let tool heat for three to five minutes before using.
5. Squeeze trigger to apply glue.
Note:
The amount of glue released depends upon how far you squeeze trigger.
6. Unplug tool when finished or if not planning to use tool within two hours.
7. Do not remove glue stick from tool. This may damage tool. Melted glue inside tool will
cool and can be stored this way. This glue will remelt when using tool next time.
8. Allow tool to cool at least 15 minutes before storing.
The HandyMaster Hot Melt Glue Gun is a multi-purpose tool. This tool is designed for home
and workshop. It performs basic fastening jobs from creating crafts and decorations to
repairing shoes and furniture. The model 33014 glue gun uses mini-sized glue sticks. The
model 33015 glue gun uses standard sized glue sticks.
WARNING
!
WARNINGICON G 001
Operating Tool
Product Overview
Do not touch melted glue or hot tool nozzle. Temperature of nozzle
reaches 380°F (193°C). Severe burns will occur.