Filter
Top Products
11
1. Loosen the sub-base mounting
screws (C) Fig. 4 just enough to
allow the sub-base (D) to move.
2. Open the clamp (A) Fig. 4, and
adjust the power unit so that the
collet nut (B) engages the center
hole in the sub-base (D). Allow the
sub-base to center itself on the
collet nut. Close the clamp (A).
3. Tighten the sub-base mounting
screws (C) Fig. 4 securely.
Fig. 5
C
D
A
B
Before attaching battery, Always make sure switch is in
the “OFF” position.
INSTALLING OR REMOVING THE BATTERY PACK
TO REMOVE THE BATTERY PACK: Depress the battery release button (B)
Fig. 6, and pull the battery pack from the tool.
TO INSTALL THE BATTERY PACK: Align the rails on the battery pack with
the slots (A) Fig. 6 on the tool. Push the battery pack until it locks in place.
STARTING AND STOPPING THE MOTOR
Before starting the router, make sure that the bit is clear of
the workpiece and foreign objects. Also keep a firm grip on
the router to resist starting torque.
Start and stop the motor by moving the switch (A) Fig. 7 to “ON” or “OFF”
position.
To avoid personal injury or damage to finished work,
always allow the motor to come to a COMPLETE STOP
before putting it down.
When through-cutting, provide enough clearance under the
workpiece for the router bit.
OPERATION
Fig. 6
A
B
Fig. 7
A
908935 - 04-04-03.qxd 4/4/03 10:02 AM Page 11