Filter
Top Products
12
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 23
P
C
P
M
V
O
G
W
P
Y
P
Z
A
B
P
B
C
10. Insert the front end of the splitter (P) Fig. 18 inside the splitter
mounting bracket behind the splitter fastener plate and the
screw (C). Push the splitter down as far as possible, making
certain that the bottom edge of the splitter (P) is parallel with
the table surface. Tighten the screw (C). Fasten the splitter
and the blade guard assembly (P) Fig. 19 to the bracket
(M), using a 5/16-18 x 1" hex-head screw (V) and 5/16" flat
washer (O).
11. IMPORTANT: The splitter (P) Fig. 20 has a notch (W) in the
top edge. Raise the front of the blade guard (G) Fig. 25, until
the rear edge of the guard slips into notch (W) of the splitter.
This notch keeps the blade guard in the raised position.
12. Attach the saw blade with the teeth pointing down at the front
of the saw table (Fig. 21). Attach the outside blade flange and
arbor nut (X). With the open end wrench (Y) on the flats of the
arbor, tighten the arbor nut by turning the box-end wrench (Z)
clockwise.
13. Use a straight edge (A) Fig. 22 to align the splitter (P) with
the saw blade (B). Use a square (C) Figs. 23 and 24 to check
the 90 degree angle of the saw blade and splitter to the
table surface. When all alignments are correct, tighten the
hardware (D) Fig. 24.