Filter
Top Products
9
Using the fence is the safest and most satisfactory method of shaping. Most straight work can be shaped using the fence
described below.
1. For average work, where a portion of the original edge of
the work is not touched by the cutter, both the front and
rear fences are in a straight line (Fig. 21).
2. When the shaping operation removes the entire edge of
the work (jointing or making a full bead), the shaped edge
will not be supported by the rear fence when both fences
are in line (Fig. 22). In this case, advance the work to the
position shown in Fig. 22 and stop.
3. Advance the rear fence to contact the work (Fig. 23),
putting it in line with the cutting circle.
REVERSING SPINDLE ROTATION
The motor is equipped with a reversing switch (X) Fig. 19, located on the motor junction box.
Never attempt to reverse the rotation of the spindle with the motor running.
DISCONNECT MACHINE FROM POWER SOURCE.
Fig. 23
When shaping with collars and starting pin, follow the rules below for superior finishing and safety in operation.
1. Free the collars of ALL gum or other substances, and confirm that they are smooth.
2. Confirm that the edge of the work is smooth. ANY irregularity in the surface that rides against the collar will be duplicated
on the molded surface.
3. A portion of the edge of the work MUST remain untouched by the cutters in order for the collar to have sufficient bearing
surface. The right method is shown in Fig. 24, while Fig. 25 illustrates the wrong method.
4. The work MUST be fairly heavy in proportion to the cut being made (Fig. 25). Under NO circumstances should short work
of light body be shaped against the collars (Fig. 27).
5. When shaping with collars and starting pin, use the spindle guard supplied with the machine.
Fig. 25
The following examples show set-up and operational procedures when using the fence, collars, and starting pin. Please review
this information carefully before turning on the power to avoid personal injury and/or damage to the machine.
Fig. 21
Fig. 22
OPERATIONS
Fig. 24
Fig. 27
Fig. 26
SHAPING WHEN USING THE FENCE AS A GUIDE
SHAPING WITH COLLARS AND STARTING PIN