Filter
Top Products
10
ENGLISH
We recommend to use professional accessories only.
• Clean and grease the bit shank.
• Insert the bit shank into the tool holder (6).
• Push the bit down and turn it slightly until it fits
into the slots.
• Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a bit pull back the tool holder locking
sleeve (12) and pull out the bit.
Fitting the side handle (fig. D)
The side handle (10) can be fitted to suit both
RH- and LH-users.
Always use the tool with the side handle
properly assembled.
• Loosen the side handle.
• For RH-users, slide the side handle clamp over the
collar behind the tool holder, handle at the left.
• For LH-users, slide the side handle clamp over
the collar behind the tool holder, handle at the
right.
• Rotate the side handle to the desired position
and tighten the handle.
Setting the drilling depth (fig. E)
• Insert the required drill bit as described above.
• Press the depth stop clamp (11) and keep it
depressed.
• Fit the depth adjustment rod (9) through the hole
in the depth stop clamp.
• Adjust the drilling depth as shown.
• Release the depth stop clamp.
Forward/reverse slider (fig. F1 & F2)
D25112(K)/D25113K/D25114K (fig. F1)
• Push the forward/reverse slider (3) to the RH-side
for forward (RH) rotation. See arrows on tool.
• Push the forward/reverse slider (3) to the LH-side
for reverse (LH) rotation.
D25213K (fig. F2)
• Push the forward/reverse slider (3) to the LH-side
for forward (RH) rotation. See arrows on tool.
• Push the forward/reverse slider (3) to the RH-side
for reverse (LH) rotation.
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
D25112(K)/D25113K/D25213K -
Fitting the chuck adapter & chuck
• Screw the chuck onto the threaded end of the
chuck adapter.
• Insert the connected chuck and adapter in the
tool as though it were a standard SDS-plus
®
bit.
• To remove the chuck, proceed as for removing a
standard SDS-plus
®
bit.
Never use standard chucks in the
hammer drilling mode.
D25114K - Replacing the tool holder with
the chuck (fig. G)
• Turn the locking collar (8) into the unlocking
position and pull the tool holder (6) off.
• Push the chuck (13) onto the spindle and turn the
locking collar into the locking position.
• To replace the chuck with the tool holder,
first remove the chuck the same way as the tool
holder was removed. Then place the tool holder
the same way as the chuck was placed.
Never use standard chucks in the
hammer drilling mode.
Replacing the dust cover (fig. C)
The dust cover (7) prevents dust ingress into the
mechanism. Replace a worn dust cover immediately.
• Pull back the tool holder locking sleeve (12) and
pull the dust cover (7) off.
• Fit the new dust cover.
• Release the tool holder locking sleeve.
Instructions for use
• Always observe the safety instructions
and applicable regulations.