Filter
Top Products
ENGLISH
28
5. To remove a chisel pull back the retainer (d) and
pull the chisel out of the tool holder (e).
D25961
TO FIT A CHISEL WITH GROOVE IN THE SHANK (FIG. 4C)
1. Pull the retainer bolt (i) and turn it by 180° to the
unlock position.
2. Hold the chisel in front of the tool holder with
the groove (h) facing upwards.
3. Insert the chisel shank into the tool holder (e).
4. Pull the retainer bolt (i) and turn it by 180° back
to the lock position.
5. Pull on the chisel to check if it is properly
locked. The hammering function requires
the chisel to be able to move axially several
centimetres when locked in the tool holder.
6. To remove a chisel pull the retainer bolt (i) and
turn it by 180° to the unlock position.
Adjusting the Side Handle (fi g. 1)
The side handle (f) is assembled on the machine to
suit both right- and left-hand users.
WARNING: Always operate the
machine with the side handle properly
mounted.
1. Loosen the clamp knob (c) and rotate the side
handle to the desired position.
2. Lock the side handle in place by tightening the
clamp knob (c).
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply a pressure of approx. 20 - 30 kg
to the tool. Excessive force does not
speed up chiselling but decreases tool
performance and may shorten tool life.
Proper Hand Position (fi g. 2)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
IMPORTANT: The tool must be held with two hands
at all times when in use.
Horizontal applications (fig. 2A):
Proper hand position requires one hand on the side
handle (f) and the other hand on the main handle (b).
Vertical applications (fig. 2B):
Proper hand position requires both hands on the
main handle (b).
Switching On and Off (fi g. 1)
Switching on: set the on/off switch (a) to position 1.
Switching off: set the on/off switch (a) to position 0.
Demolition, Chasing and Channelling
(fi g. 1, 2)
1. Select the appropriate chisel, and clean its
shank.
2. Insert the chisel and check whether it is properly
locked.
3. Fit and adjust the side handle (f) and make sure
it is firmly tightened.
4. Hold the tool with two hands on the main
handle (b) or one hand on the main handle (b)
and one hand on the side handle (f). The tool
must be held with two hands at all times when
in use. Refer to Proper Hand Postion.
5. Switch on tool to run in continuous operation.
6. Always switch off the tool when work is finished
and before unplugging.
Various types of chisels are available as an option.
Only DEWALT recommended accessories should be
used with this product.
MAINTENANCE
Your DEWALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning
This machine is not user-serviceable. Take the tool
to an authorised D
EWALT repair agent periodically.
If problems occur before this time contact an
authorised DEWALT repair agent.
Accessory Maintenance (fi g. 5, 6)
WARNING: These chisels can be
reground only a limited number of
times. If in doubt, contact your dealer for
recommendations.