Filter
Top Products
5
English
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on
the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA repiratory protection.
WARNING: When cutting into walls, floors or wherever live
electrical wires may be encountered, DO NOT TOUCH ANY METAL
PARTS OF THE TOOL! Hold the tool only by insulated grasping
surfaces to prevent electric shock if you cut into a live wire.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ............volts A .........amperes
Hz ..........hertz W ........watts
min ........minutes
......alternating current
.....direct current ......alternating or direct
..........Class I Construction ...........current
..............(grounded)
n
o .......no load speed
..........Class II Construction ........earthing terminal
..............(double insulated) .......safety alert symbol
…/min ...per minute
BPM ...beats per minute
RPM ......revolutions per minute
FEATURES
C
A
D
F
B
E
A. End cap
B. Trigger switch
C. Bevel angle adjustment
D. Shoe
E. Blade clamping screw
F. Lower blade guard
Motor
Your DEWALT tool is powered
by a D
EWALT motor. Be sure
your power supply agrees with
nameplate marking. As little as 10% lower voltage can cause loss of
power and can result in overheating. All D
EWALT tools are factory-
tested; if this tool does not operate, check the power supply.
Changing Blades
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.