Filter
Top Products
Installing Spark Guards and Eye Shield
Brackets
TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY
The combination spark guard and eye shield brackets are assembled
and in a plastic bag. They are identified L for left and R for right. Refer
to Figure 3 to install them to the bench grinder using the two screws
in the wheel guard (in some cases these screws will be in the plastic
bag). Adjust the edge of the spark guard to within 1/16” of the
grinding wheel or other accessory as shown in the figure. Tighten the
two screws securely.
2
SAVE THESE INSTRUCTIONS
Motor
Be sure your power supply agrees with the nameplate marking. 120
Volts, 50/60 Hz means alternating current only should be used to
operate this tool.A power decrease of more than 10% will cause loss
of power and overheating. All DeWalt tools are factory tested; if this
tool does not operate, check the power supply
Bench Mounting
1. The grinder should be unplugged.
2. Remove the drilling template from this manual (pg. 5) and place it
in position of the bench. Check for the availability of power for the
grinder. Tape the template to the bench.
3. Using a center punch, transfer the hole centers for drilling.
4. Drill appropriate sized holes.
5. Insert 1/4” (6mm) Hex head bolts through washers and the holes.
You may want to use washers on the underside of the bench as
well.
6. Tighten the nuts. Do not overtighten. Allow the rubber feet to
absorb the vibration when the grinder is running.
Installing Tool Rests
TURN OFF POWER AND DISCONNECT FROM POWER SUPPLY.
Your grinder includes a hex wrench, attached to the right of the
On/Off switch. Use this wrench when installing the tool rest brackets,
tool rest and eye shield brackets.
First install the tool rest brackets, as shown in Fig. 2. Next attach the
tool rests. Use the bolts, washers, spacers and lock nuts from the
plastic bag to secure the brackets and tool rests in place.
NOTE: There is a left and right tool rest. When in actual use, the tool
rests should be adjusted to within 1/8” of the grinding wheel or other
accessory being used.
English
FIG. 1
SWITCH (ON - OFF)
EYE SHIELD BRACKETS
SPARK GUARDS
TOOL RESTS
COARSE
GRINDING
WHEEL
(36 GRIT)
MEDIUM
GRINDING
WHEEL
(60 GRIT)
EYE SHIELDS
DW756 - 6” Bench Grinder 1/2”(13mm) Arbor, 3450 RPM
DW758 - 8” Heavy Duty Bench Grinder 5/8”(16mm) Arbor, 3600 RPM
DW756,758/385498 8/20/01 7:43 AM Page 2