Filter
Top Products
13
English
Using An Angle Die Grinder Continued
12) Always shut off the air supply to the tool and depress the
trigger to release air from the feed hose before fitting,
adjusting or removing the working attachment.
13) Check hoses and fittings regularly for wear. Replace if
necessary. Do not carry the tool by its hose. Ensure the
hand is removed from the on/off trigger when carrying
the tool with the air supply connected.
14) Take care against entanglement of moving tool parts
with clothing, ties, hair, cleaning rags, etc. This will
cause the body to be drawn towards the tool and can
be very dangerous.
15) Safe working practices and observe all relevant legal
requirements when installing, using or maintaining the tool.
16) Only install the tool when an easily accessible and easily
operable on/off switch is incorporated in the air supply.
17) Take care that the tool exhaust air does not
cause problems or blow onto another person.
18) Never lay a tool down unless the working attachment has
stopped moving.
PRE-START CHECKLIST (FIG. 1, PG. 2)
•Drainwaterfromaircompressortankandcondensationfrom
air lines. (Please refer to air compressor’s operation manual.)
•Lubricatethetool.(Pleaserefertothe“Maintenance”section
in the manual.)
•Selecttherequiredattachment.Themandreloftheattachment
must match the size of the collet on the air grinder.
WARNING: Risk of unsafe operation. Firmly grasp air hose
with hand when installing or disconnenting to prevent hose whip.
WARNING: Risk of bursting. Too much air pressure causes
a hazardous risk of bursting. Check the manufacturer’s maximum
pressure rating for air tools and accessories. The regulator output
pressure must never exceed the maximum pressure rating.
INSERT TOOL ASSEMBLY (FIG. 1, PG. 2)
•Loosenthecollet (C) on the air die grinder by holding the
spindle (A) with the supplied 11mm wrench while loosening
the collet nut (B) with the supplied 17mm wrench.
•Insertmandrelofaninserttoolintothecollet (C) and tighten
by fastening the collet nut (B) with the 17mm wrench.
NOTE: Always check the weariness of the insert tool in order to
increase the efficiency and safety of the air grinder.
IMPORTANT: Before using this tool, ensure that the insert tool is
fixed in the collet very tightly.
FASTEN
LOOSEN
FASTEN
LOOSEN
11MM WRENCH
17MM WRENCH