Filter
Top Products
USER GUIDE
1. Plug the wall charger directly into an AC outlet; the blades are non-polarized so it will
work correctly in either direction.
2. Plug the USB connector into the wall charger and plug the other end into your
pocket cam.
a. The small adapter that is included in this kit is required to
charge Flip Video cameras from a USB power source other than a computer.
Plug this adapter into the wall charger rst for Flip Video cameras.
3. Your device should now indicate it is being charged. If it does not make sure the
outlet is getting power (there may be a switch that controls the outlet).
4. This charger will work with any other portable device that charges via USB. It will
require the specic charge cable for that device.
If an over voltage condition occurs the unit will stop working to protect your device.
Unplug the charger, wait for 10 seconds then plug it back in. Continue to use as
normal.
All brands represented herein are registered trademarks of their respective manufacturers.
Todas las marcas representadas aquí son marcas comerciales registradas de sus fabricantes respectivos.
Toutes les marques représentées ici sont des marques déposées de leurs fabricants respectifs.
100240V
50HZ ~ 60HZ
5V
1A
Failure to read and follow these safety instructions could result in re, electrical shock
or other hazard, causing serious and/or fatal injury and/or property damage.
1. Do not modify, disassemble, open, or crush the product
2. Do not expose the product to rain or water
3. Keep away from open ame or sunlight to prevent heat build-up
4. This product is not a toy. Keep away from children. Insure that all persons who use
the product read and follow these warnings and instructions.
Mizco’s responsibility with regard to this limited warranty shall be limited solely to the
repair or replacement at its option, of any product, which fails during normal consumer
use for a period of 1 Year from the date of purchase. This warranty does not extend
to damage or failure, which results from misuse, neglect, accident, alteration, abuse,
improper installation or maintenance. If at any time during the 1 Year period following
the purchase the product fails due to defects in materials or workmanship, return the
defective product with freight prepaid and proof of purchase.
All brands represented herein are registered trademarks of their respective
manufacturers. Design and specications are subject to change without notice.
| 1
| 2 | 3
WALL CHARGER FOR POCKET CAMS
CARGADOR DE PARED PARA CÁMARAS DE BOLSILLO
CHARGEUR MURAL POUR CAMÉRAS DE POCHE
Wall Charger
USB extension cable
Flip Video Charge Adapter
Mini B USB Cable not pictured
EnglishUSER GUIDE
©2010 Mizco International, Inc. Avenel, New Jersey
www.mizco.com tel: 800•266•4026
email: digipowersolutions@mizco.com
All rights reserved. Todos los derechos reservados.
Tous droits réservés.
DIGIPOWER is a registered trademark of Mizco
International Inc.
DIGIPOWER es una marca registrada de Mizco
International Inc.
DIGIPOWER est une marque de commerce enregistrée
de Mizco International, Inc.
ear rranty
Garano
Gara
We, Mizco International, Inc., of 80 Essex Ave East, Avenel, NJ 07001, declare under our sole responsibility that the product ACD-PCAM to which this declaration
relates, complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Mizco International, Inc., is not responsible for any interference caused by unauthorized modications to this equipment. Such modications could void the
user’s authority to operate this equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Nosotros, Mizco International, Inc., de 80 Essex Ave East, Avenel, NJ 07001, declaramos bajo nuestra responsabilidad única que el producto ACD-PCAM
relacionado con esta declaración, cumple con la Parte 15 de las reglas de la FCC. Su operación está sujeta a las siguientes dos condiciones: (1) este dispositivo
no puede causar interferencia dañina, y (2) este dispositivo deberá aceptar cualquier interferencia recibida, incluyendo interferencia que pudiera causarle una
operación no deseada.
Este equipo ha sido probado y se encontró que cumple con los límites establecidos para un dispositivo digital Clase B, de conformidad con la sección 15 de
las reglas de la FCC. Estos límites están diseñados para ofrecer una protección razonable contra interferencia perjudicial cuando el equipo se opera en una
instalación residencial. Este equipo genera, usa y puede emitir energía de radio frecuencia y si no se instala y usa de acuerdo con las instrucciones podría
provocar interferencia perjudicial a las comunicaciones de radio. Sin embargo, no hay garantía de que dicha interferencia no ocurrirá en una instalación en
particular. Si este equipo ocasiona interferencia perjudicial a la recepción de radio o televisión, lo cual se puede determinar apagando y encendiendo el equipo,
se sugiere que el usuario trate de corregir la interferencia mediante una de las siguientes medidas:
• Colocar u orientar la antena receptora en otro lado.
• Aumentar la separación entre el equipo y el receptor.
• Conectar el equipo una salida o circuito distinto al que está conectado el receptor.
• Consultar a su proveedor o un técnico de radio o televisión con experiencia para que le ayuden.
Mizco International, Inc. no es responsable por cualquier interferencia causada por modicaciones no autorizadas a este equipo. Dichas modicaciones podría
invalidar la autorización del usuario para operar este equipo.
Este aparato digital Clase B cumple con el ICES-003 de Canadá.
Nous, Mizco International, Inc., sis au 80 Essex Ave East, Avenel, NJ 07001, déclarons sous notre seule responsabilité que le produit ACD-PCAM auquel se réfère la
présente déclaration, est conforme aux normes énoncées à l’alinéa 15 de la réglementation FCC. Le fonctionnement est assujetti aux deux conditions suivantes:
(1) cet appareil ne peut pas provoquer d’interférence nuisible, et (2) cet appareil doit accepter toute interférence reçue, y compris des interférences pouvant
entraîner un fonctionnement non désiré.
Cet appareil a été contrôlé et jugé conforme aux limites imposées pour les unités numériques de classe B, en vertu de l’alinéa 15 de la réglementation FCC.
Ces limites visent à assurer une protection raisonnable contre les interférences en milieu résidentiel. Cet appareil génère, utilise et peut émettre de l’énergie
radioélectrique et, s’il n’est pas installé et utilisé selon les instructions fournies, il peut causer des interférences dans les communications radio. Néanmoins,
aucune installation n’est par dénition exempte de ce phénomène. Si cet appareil cause eectivement des interférences nuisibles lors de la réception d’émissions
radio ou télévisées (et il sut, pour s’en rendre compte, d’allumer et d’éteindre l’appareil), l’utilisateur devra tenter de corriger ces interférences en prenant l’une
des mesures suivantes:
• Réorienter ou changer la position de l’antenne réceptrice.
• Augmenter la distance entre l’équipement et le récepteur.
• Brancher l’équipement sur une prise de courant appartenant à un circuit diérent de celui sur lequel est branché le récepteur.
• Demander l’assistance du fournisseur ou d’un technicien de télé ou de radio expérimenté.
Mizco International, Inc., n’est pas responsable des interférences causées par des modications non autorisées de cet équipement. De telles modications
peuvent rendre nulle l’autorisation accordée aux utilisateurs de se servir de cet équipement.
Ce périphérique numérique de classe B est conforme à la norme canadienne ICES-003.
Thank you for purchasing the DigiPower wall charger for Pocket Cams. This product
has been designed to provide fast charging times, Universal auto switching 100-240V,
over voltage and short circuit protection, all in a compact size, perfect for travel.
This package includes a 1 meter (3.3 ft) charge/sync mini B cable, a 1 meter (3.3 ft)
charge/sync USB extension cable, and a Flip Video charge adapter. The cables can be
used to connect your pocket cam or other portable devices directly to your computer
for charge and sync operations or connect to the included wall charger to power your
devices wherever there is an AC outlet.