Filter
Top Products
Operating instructions:
1. While the battery is on the cradle, connect the base charger to a power source.
The Charging Meter will light up.
The meter will begin to blink at the start of each charging level.
Less than 25% capacity, the 1
st
LED will blink.
Less than 50% capacity, the 2
nd
LED will blink.
Less than 75% capacity, the 3
rd
LED will blink.
Less than 100% capacity, the 4
th
LED will blink.
When the battery is fully charged, the charging meter will be fully lit and will stop blinking.
(The typical charge time is 1-hour for batteries up to 900mAh.)
NOTE:
The charger or battery may become warm when charging. This is a normal occurrence.
CAUTIONS:
Always unplug the charger while not in use.
Do not store, place or use the charger where it may come into contact with water or moisture.
Always replace frayed or damaged wire and broken plugs immediately.
To reduce the risk of electric shock, unplug your charger from the wall outlet before cleaning.
Do not open or disassemble the charger unit.
Maintenance:
Use a clean, DRY cloth when necessary to keep the metal contacts of both the charger and the battery clean.
(Remove from power outlet before cleaning.)
LIMITED WARRANTY:
This product carries a full one-year warranty from date of purchase against defects in materials and workmanship.
This warranty does not cover damage resulting from accidents, misuse, unauthorized repair/alternations to the
product or failure to follow operating instructions.
Visit our web site: www.digipowersolutions.com
Email: cs@digipowersolutions.com
Battery
Base
Charger
Battery
Plate
Charging
Meter