Filter
Top Products
7
©
1999 Directed Electronics, Inc.
To disarm the system and unlock the doors of the vehicle, press
for one second. The Failsafe® Starter Kill will be deactivated
and the vehicle’s horn (if connected) will honk twice. The parking
lights will also flash twice (if connected). The red LED will go out,
unless the system is programmed for passive mode. If programmed
for passive mode, the LED will begin to flash rapidly when the sys-
tem is disarmed. This indicates that the system will re-engage the
Failsafe® Starter Kill relay and re-lock the doors (if passive locking
is selected) in 30 seconds unless the key is turned on.
NOTE: If the system has been armed with the remote transmitter, you
must use the transmitter or the Valet switch to disarm the system and
deactivate the starter kill. Manually unlocking the vehicle does not dis-
arm the system; it will only unlock the doors.
This feature allows you to override the starter kill without the
transmitter should it be lost, damaged or disabled. To do this, you
must have the ignition key and know where the Valet® switch is
located. Check with the installer for the location of the Valet® switch.
Turn the ignition to the "run"
position. Press and release the
Valet® switch, within 10 seconds.
The LED will stop flashing and the
vehicle should start. If it does not,
you may have waited too long.
Turn the ignition off and try again.
DRW-35
Disarming the Failsafe® Starter Kill without a Transmitter
Disarming/Unlocking