Filter
Top Products
71
Figure 4.4.6.3
1. Select “/ Volume configuration / Virtual disk”.
2. Click “Create”.
3. Input a VD name, choose a RG Name and enter a size for this VD; decide the stripe
height, block size, read / write mode, bg rate, and set priority, finally click “OK”.
4. Done. A VD has been created.
5. Follow the above steps to create another VD.
Figure 4.4.6.4
(Figure 4.4.6.4: Creating VDs named “VD-R5-1” and “VD-R5-2” from RAID group “RG-R5”, the
size of “VD-R5-1” is 50GB, and the size of “VD-R5-2” is 64GB. There is no LUN attached.)
Step 3: Attach a LUN to a VD.
There are 2 methods to attach a LUN to a VD.
1. In “/ Volume configuration / Virtual disk”, check the gray button next to the VD
number; click “Attach LUN”.
2. In “/ Volume configuration / Logical unit”, click “Attach”.
The procedures are as follows: