Filter
Top Products
30
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a DOLMAR service center.
Page
Service, spare parts and guarantee
Maintenance and repair
The maintenance and repair of modern cutoff saws and their safety-related components requires qualied technical training and a
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a DOLMAR service center for all work not described in this instruction manual.
The DOLMAR service centers have all the necessary equipment and skilled and experienced personnel, who can work out cost-
effective solutions and advise you in all matters.
Please contact your nearest service center (list enclosed) or the general trading company or importer (see last page), who will gladly
provide you with the address of your nearest DOLMAR service center.
Spare parts
Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts
used. Use only original DOLMAR parts, marked
Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materi-
als, dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions and function.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original DOLMAR spare parts are used, this will automatically invalidate the DOLMAR
product guarantee.
We will furthermore not accept any liability damages arising from the use of non-DOLMAR spare parts.
General Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualied service center immediately
Cutting disc Inspect regularly for damage and wear. 7
Clutch Have inspected at a service center.
Protection hood Clean, Check position (impact plate) 18
Before each start Cutting disc Inspect for damage and make sure the cutting wheel is 7
right for the job
V-belt Check V-belt tension 15
Protective hood Adjust position
Combination switch, Functional check
Safety locking button, Functional check
Throttle lever Functional check 18
Tank cap Check for tightness and lekages
Every day Air lter Clean (if necessary more frequently); pre-lter (foam)
maintenance as described above under Cleaning /
changing the air lter 22-23
Idle speed Check (cutting disc must not turn on idle) 20
Extreme dust Clean lter insert (paper cartridge) 22-23
Every week Starter housing Clean to ensure proper air cooling 13
Starter cable Check for damage 25
V-belt Check V-belt tension, inspect for damage and wear 15, 21
Air lter insert Clean, replace after 100 operating hours 22-23
Spark plug Check and replace if necessary 24
Mufer Check tightness of mounting, clean or replace 13 / 28
spark arrester screen if necessary
Every 3 months Suction head Replace 24
Fuel tank Clean
Annually Entire Power Cut Check at an authorized service center
Storage Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualied service center immediately
Cutting disc Remove and clean 14
Fuel tank Empty and clean
Carburetor Run empty