Filter
Top Products
14
Place the spring washer (8) on the arbour and insert the screw
(9) and tighten by hand.
Turn the disc slowly until the stop hole of the V-belt pulley is
visible in the cutting arm cover (10).
Insert the Allen key (2) as far as it will go. The shaft is now
blocked.
Tighten the screw with the combination wrench (1)
NOTE: Tighten the screw rmly (30 ± 2 Nm), as otherwise
the cutting wheel may slip during cutting.
Mounting the cutting disc
Inspect the disc for damage.
See SAFETY INSTRUCTIONS, Page 7.
Unscrew screw (9) and remove the spring washer (8).
Place the cutting disc (5) on the arbour (7).
Hinweis: The arbor hole of the cutting disc must be an exact
t with the arbor or shaft. If the arbor hole is larger, it must be
tted with an adapter ring (*).
Make sure the cutting disc is installed so it turns in the right
direction, if a direction is marked on the disc.
PUTTING INTO OPERATION
CAUTION:
Always turn off the engine and pull off the spark plug cap
before doing any work on the Power Cut! Always wear
protective gloves!
CAUTION:
Start the Power Cut only after complete assembly and
inspection.
Sequence
For the the following work, use the assembly tools included
with delivery:
1. 13/19 AF combination wrench
2. Allen key
3. Carburetor adjustment screwdriver
4. Adapter ring (not in the general delivery inventory)
Place the Power Cut on a stable surface and carry out the fol-
lowing assembly steps:
Only for models PC-8135 and 8140
No air lter is installed!
Before operation, insert an oiled foam
lter (pre-lter), as shown in the adja-
cent illustration! To do this, take off the
lter cover (see the chapter on Cleaning /
changing the air lter).