Filter
Top Products
19
Speed Settings (Continued)
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
453, 454, -- -25-35 ----
455
Chain Saw Sharpening Stones
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
461, 462, 463 -- -18-24 18-24 18-24 18-24 18-24
414, 422, 429 -- -12-17 12-17 12-17 12-17 12-17
425, 427 -- -18-24 18-24 ---
423E -- -12-24 5-8 5-8 5-8 12-24
403, 404, 405 9-11 9-11 5-11 12-15 5-8 ---
530, 531, 532 - 9-11 - 9-11 ----
428, 442, 443 9-11 9-11 5-8 9-11 9-11 ---
535, 536, 537 9-11 9-11 - 9-11 9-11 9-11 --
Polishing Accessories
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
430, 431, 438 5-35 5-35 5-17 25-35 25-35 5-35 5-35 -
439, 440, 444 5-35 5-35 5-17 25-35 25-35 5-35 5-35 -
407, 408, 432 5-35 5-35 5-17 25-35 25-35 5-35 5-35 -
411, 412, 413 12-17 12-17 5-8 - 5-8 ---
Sanding Bands and Discs
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
409, 420, 426 -- 5-11 25-35 25-35 25-35 25-35 -
540, EZ409
542, EZ544 25-35 18-35 5-11 -- --
545, EZ545 18-35 18-24 ---12-24 12-24 -
560 For use on drywall. For best results, use at 30,000 rpm.
561 12-35 12-35 5-11 - 25-35 ---
562 -- - - - -25-35
EZ456 -- -25-35 25-35 ---
EZ476 - - 5-11 -----
Cutting Accessories
* Speed for light cuts; Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Note: Each number settings listed in the speed charts = 000 RPM’s
DM 2610005595 05-09:DM 2610005595 05-09 5/27/09 2:39 PM Page 19