Filter
Top Products
15
Service
NO USER SERVICEABLE PARTS
INSIDE. Preventive mainte-
nance performed by unauthorized personnel may
result in misplacing of internal wires and compo-
nents which could cause serious hazard. We
recommend that all tool ser
vice be performed by a
Dremel Service Facility.
D.C. motors
The motor in your tool has been engineered for
many hours of dependable service. To maintain peak
efficiency of the motor, we recommend it be exam-
ined every six months. Only a genuine Dremel
replacement motor specially designed for your tool
should be used.
Cleaning
To avoid accidents, always dis-
connect battery pack from tool
before cleaning. The tool may be cleaned most
effectively with compressed dr
y air. Always wear
safety goggles when cleaning tools with com-
pressed air
.
Ventilation openings and switch levers must be kept
clean and free of foreign matter
. Do not attempt to
clean by inserting pointed objects through opening.
Certain cleaning agents and
solvents damage plastic parts.
Some of these are: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and house-
hold detergents that contain ammonia.
!
WARNING
Maintenance
!
WARNING
!
CAUTION
To replace a band on the Drum Sander, loosen the
screw without removing it to contract the drum
then slide the old band off. Slide the new sanding
band on and then expand the drum by tightening
the screw once again.
Before each use, check to
make certain that all compo-
nents are assembled to accessor
y shank and that
the drum is sufficiently expanded to secure the
band during use. If sanding band is loose on the
drum during operation it may “fly” off and strike
you or bystanders.
!
WARNING
DM 2610000602 05-08 5/19/08 9:35 AM Page 15