Electrolux ESL 66010 Welding System User Manual


 
26 electrolux daily use
Cancelling the delay start
To cancel a delay start in progress
you have to reset the dishwasher.
Simultaneously press and hold the
two programme buttons positioned
over the word Cancel, until all the
programme button lights will
illuminate.
Cancelling a delay start involves
also the cancelling of the washing
programme set. In this case you
have to set the washing
programme again.
Cancel a washing programme in
progress
Simultaneously press and hold the
two programme buttons positioned
over the word Cancel, until all the
programme button lights illuminate.
The washing programme has been
cancelled.
If a new washing programme is to
be selected, check that there is
detergent in the detergent
dispenser.
End of the washing programme
The dishwasher will automatically
stop and an audible signal informs
you of the end of the washing
programme.
Open the dishwasher door.
The indicator light of the
programme just ended will remain
on.
1. Switch off the dishwasher by
pressing the On/Off button.
2. Leave the dishwasher door ajar
and wait a few minutes before
removing the dishes; in this way
they will be cooler and the drying
will be improved.
When the washing programme has
ended, the optical signal on the floor
beneath the dishwasher’s door will
turn off.
Unloading the dishwasher
Hot dishes are sensitive to knocks.
The dishes should therefore be
allowed to cool down before
removing from the appliance.
Empty the lower basket first and
then the upper one; this will avoid
water dripping from the upper
basket onto the dishes in the lower
one.
Water may appear on the sides
and the door of the dishwasher as
the stainless steel will eventually
become cooler than the dishes.
When the washing programme has
finished, it is recommended that
the dishwasher is unplugged and
the water tap turned off.
117989 83/0en 20-02-2007 17:34 Pagina 26