Filter
Top Products
2.12
PK 255
1. Take blade guard off.
2. Remove the two fastening screws of the remov-
able table section.
3. Raise blade fully.
4. Lift chip case cover slightly and swing to the
side. The cover is hooked into the bottom of the
chip case and can not fall down.
5. Loosen nut on riving knife by approx. one turn.
6. Adjust riving knife position.
7. Tighten nut.
Lateral offset
Riving knife and saw blade must be exactly in line
(make trial cut). The alignment needs to be checked
after every setting of the distance riving knife - saw
blade.
· Turn set screws (arrow) clockwise
= riving knife is set to the right.
· Turn set screws (arrow) counter-clockwise
= riving knife is set to the left.
8. Slide chip case cover back into the closed posi-
tion and tighten screws.
9. Attach blade guard.
10. Fasten removable table section.
Blade tilt stop setting
1. Raise blade fully and set at true 90˚ against the
table with the help of a try square.
2. If the 0˚ (90˚) stop does not exactly match the
saw blade position:
lower saw blade completely, turn saw upside
down and place on its saw table.
3. Adjust backstop setting screws on both front
and rear of the saw until blade is in exact 0˚ posi-
tion when set against the 0˚ stop.
4. To check the setting of the 45˚ backstop, repeat
steps 1 to 3 accordingly.
5. After resetting any of the backstops, check
bevel tilt scale on the machine’s front, adjust if
necessary.
Scale setting
The rip fence scale needs to be set according to the
position and thickness of the saw blade.
1. Place rip fence against the right-hand edge of
the saw blade and lock in position.
The "0"-mark of the scale should now be directly
underneath the left-hand edge of the rip fence
extrusion (arrow). If not:
- loosen fixing screw and reposition scale.
- tighten fixing screw and remove rip fence.
0