Filter
Top Products
15
ENGLISH
A
Danger!
Prior to all servicing:
− Switch Off.
− Unplug.
− Wait until the compressor has
come to a complete stop.
− Ensure the compressor and all air
tools and accessories connected
to it are relieved from pressure.
After all servicing:
− Check to see that all safety
devices are operational.
− Make sure that no tools or other
parts remain on or in the
machine.
Compressor does not run:
• No mains voltage.
− Check cables, plug, outlet and
mains fuse.
• Mains voltage too low.
− Use only extension cables with
sufficient lead cross section (see
"Technical Specifications"). Avoid
using extension cable with cold
machine.
• Compressor was stopped by
unplugging.
− Switch compressor OFF at the
On/Off switch, then ON again.
• Motor has overheated, caused by
insufficient cooling (cooling fins cov-
ered).
− Remove cause for overheating
and allow to cool down for
approx. 10 minutes, then start
again.
Compressor runs but does not build
up sufficient pressure.
• Drain cock on cup of filter/regulator
unit open.
− Close drain cock.
• Check valve leaky.
− Have check valve serviced by
qualified service centre.
Air tool is not supplied with sufficient
pressure.
• Pressure regulator not opened wide
enough.
− Open pressure regulator more.
• Hose connection between compres-
sor and air tool leaky.
− Check air hoses, replace defec-
tive parts if necessary.
A
Danger!
Repairs to electric tools must
be carried out by qualified electrici-
ans only!
Electric tools in need of repair can be
send to the service centre in your coun-
try. See spare parts list for address.
Please attach a description of the fault to
the electric tool.
The machine's packaging can be 100 %
recycled.
Worn out machines and accessories
contain considerable amounts of valua-
ble raw and plastic materials, which can
be recycled.
These instructions are printed on chlo-
rine-free bleached paper.
7. Trouble Shooting
8. Repairs
9. Environmetal protection
10. Technical Specifications
Suction capacity l/min 380
Free air delivery (volume flow rate) l/min 240
Filling rate l/min 280
Working pressure (compression end pressure) bar 10
Pressure vessel volume l 60
No. of air outlets 2
Compressor pump type B 3800 B
No. of cylinders 2
Speed (compressor pump) min
-1
1150
Motor capacity kW 2.2
Supply voltage (50 Hz) V 230
Rated current A12.5
Fuse protection min. A 16 (time-lag)
Degree of protection IP 54
Max. overall cable length when using extension cables:
– at 3 x 1.5 mm
2
lead cross section
– at 3 x 2.5 mm
2
lead cross section
m
m
15
25
Oil grade (compressor pump) SAE 40
Required oil quantity (compressor pump) l 1.0
Dimensions length x width x height cm 110 x 46 x 81
Weight kg 79
Sound pressure level L
PA
at 4 m max. dB (A) 72 ± 3
Sound power level L
WA
dB (A) 92