Filter
Top Products
15
MODEL 396/396VP/397/398/398VP SECTION 2.0
INSTALLATION
2.3 ELECTRICAL INSTALLATION.
The Models 396, 396VP, 397, 398, and 398VP are for use
with a remote preamplifier. Each sensor comes with either a
special 15 ft low noise coax cable or a Variopol (VP) con-
nector, which is used with a mating Variopol cable. The
cable should be handled carefully, and kept dry and free of
corrosive chemicals at all times. Extreme care should be
used to prevent the cable from being twisted, damaged or
scraped by rough, sharp edges or surfaces. Please refer to
Figures 2-7 thru 2-18 for wiring Models 396, 397, and 398.
Please refer to Figures 2-19 thru 2-36 for wiring Models
396VP and 398VP.
DANGER
DO NOT CONNECT SENSOR CABLE TO POWER
LINES. SERIOUS INJURY MAY RESULT
.
FIGURE 2-7. Models 396, 397, and 398 Standard Wiring
Option used with Models 1054A, 1054B, 2054, and
Preamplifiers PN 22698-02 and 22698-03.
FIGURE 2-8. Models 396, 397, and 398 Option -62 for
Wiring to Models 1054, 1181, 2081, 54, 81, 3081, 4081,
SoluComp, and 2700 Preamplifier (PN 23054-03). Also for
use with remote Junction Box PN 23555-00.
FIGURE 2-6. Recommended Flow-Through and Insertion Installation For Model 397
DWG. NO. REV.
40039703 B
NOTE
Remove electrical tape or shrink sleeve from gray refer-
ence wire before connecting wire to terminal.